Name: POLISHING BONNET WOOL HOOK AND LOOP CONCAVE 180MM 7'
Brand: TORK CRAFT
SKU: SPC00125
Price: 376.63 ZAR
Availability: InStock

POLISHING BONNET WOOL HOOK AND LOOP CONCAVE 180MM 7'

Based on 0 reviews. - Write a review

Price

R 376.63

Ex VAT: R 327.50

Item No: SPC00125
Weight: 0.22kg
Dimensions: 350.00mm x 270.00mm x 40.00mm
SKU: SPC00125
UPC: 6009515825218

Available Options

Ask Question Ask Question

Add to Wish List

Tags: hook and loop polishing wool buff , Polishing , Brand TORK CRAFT

hook and loop polishing wool buff

Diameter: Ø180mm
Use backing pad: SPC00119

Application:

The polishing wool buff should be used with an automotive polisher. Different polishes and waxes can be used with the buff. The buff is fastened onto a rubber backing pad with hook and loop. Make sure the diameter of the polishing buff is the same as the backing pad's diameter.

It is necessary to polish a vehicle body panel when:

The panel has been newly painted with a clear-coat.
Shallow scratch marks need to be removed.
The panel has suffered from oxidation.
Swirl marks and hologram defects need to be removed.

TIP:
The buff is washable after use if the polishing compound is soluble.

hook and loop polishing wool buff range:

ORDER NO.	DIAMETER	USE BACKING PAD
SPC00123	ø125mm	SPC00120
SPC00125	ø180mm	SPC00119

hook and loop polishing wool buff

Steps to take when polishing a panel:

1. Preparing the panel:

Sometimes a panel has fine over-spray left from spraying the clear-coat. This needs to be removed by lightly sanding with a fine abrasive paper. All over-spray need to be sanded out up to P1500 grit.
The panel should be washed when all spray-finishing defects have been removed. Any dirt particles could cause scratch marks when polishing.
Tight curves and ends of the panel should be masked-off to prevent the effects caused by point pressure. The polisher should always be used on flat surfaces.

2. Applying the polishing compound:

A five rand coin amount of polishing compound should be applied to the buff. Switch the polisher to it's lowest speed setting.
Switch on the polisher and gradually spread the polishing compound over the panel.
Keep moving the polisher on the panel to have as little amount of pressure and friction.
The polishing compound will remove the scratch marks caused by the P1500 sand paper and it will bring out an impressive gloss finish.
Remove the masking from the panels and apply the polishing compound to a microfiber cloth. Hand polish (by moving your hand in a small circular motion) the tight curves and ends in the panels until the same finish is achieved as from the polisher.

3. Wash the panel when finished:

Wash the panel after polishing to remove any residue from the polishing compound.

consider safety for your health and the people around you
General safety suggestions: It is advisable to always have the following items nearby and in a good condition Eye protection – clean and scratch free Hearing protection – quality earmuffs Dust masks – discard old and dirty masks Gloves – for easy handling of material and hand protection

Wear Gloves	Eye Protection	Hearing Protection	Dust Mask