Multi Metal Lock High Strength Bond & Sealing 50g Blister Card

Extra Information

• Ensure all metal surfaces are clean, dry and completely free of oil, grease, rust or paint before application — degrease and clean thoroughly for maximum bond strength.
• Apply a thin, even layer of adhesive to one mating surface before assembly — avoid excess which could squeeze into bearings or lubricant passages.
• After assembly, allow parts to handle lightly after approx. 30 – 60 minutes; full cure strength is typically reached within 24 hours depending on metal type, temperature and fit tolerance.
• Not suitable for non-metal materials such as plastic, rubber or wood — only use on ferrous metal components intended for permanent bonding or sealing.
• Store container tightly sealed in a cool, dry place away from direct sunlight or heat to preserve shelf life.

Features

• High-strength anaerobic formula — creates a permanent, rigid bond between metal parts when assembled.
• Suitable for multiple metals — effective on steel, cast iron and other ferrous metals; ideal for shafts, housings, bearings and threaded joints.
• Sealing and locking in one — simultaneously locks components in place and seals against leaks, moisture or lubricant seepage.
• 50 g container — sufficient for several assemblies or maintenance jobs.
• Cures only between metal surfaces — avoids premature curing when stored or on exposed surfaces.

Benefits

• Permanent, maintenance-free joints: once cured, bonded parts stay secure under load and vibration — ideal for gearbox housings, motor shafts, structural assemblies or heavy-duty machinery.
• Improved reliability and safety: reduces risk of loosening, fretting or leakage in rotating or load-bearing metal assemblies.
• Eliminates need for welding or press-fit tolerances: simplifies assembly and maintenance by providing strong bonds without special tooling or exact tolerances.
• Versatile industrial use: suitable for sealing and bonding in bearings, housings, bushings, couplings, threaded joints and shaft assemblies.
• Cost-effective solution: reduces downtime and maintenance, especially for assemblies exposed to vibration, heat or repeated stress.

Safety

• Use in a well-ventilated area and avoid inhaling vapours.
• Wear nitrile or chemical-resistant gloves when handling the adhesive; avoid skin and eye contact. In case of contact, rinse thoroughly with water and seek medical advice if irritation persists.
• Keep away from open flame, sparks or sources of ignition; store sealed in a cool, dry place.
• Do not apply to oily, wet or rusted surfaces — ensure parts are clean and dry before use.
• Keep out of reach of children. Dispose of empty container according to local waste-disposal regulations for chemical products.

Specifications